Standby Group conflict with the Virtual Blade NIC

Unanswered Question
May 8th, 2009

I'm running oe574-4.1.3.55 on a WAE574, I've created Standby Group 1 but when I tried to map the virtual-blade to the NIC it failed with following error:

GigabitEthernet 1/0 is part of an Standby group. To use this interface in a virtual blade, it must be removed from

the Standby group.

Is it not possible to use "standby group" with the virtual-blade ?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion