05-09-2009 03:51 AM - edited 07-03-2021 05:34 PM
Hi netpros,
I am having an issue when upgrading several access points to LWAPP. The a radio is unable to associate to the controller due to regulatory domain mismatch. I have read that vesion 5.X supports multiple regulatory domains. How can I enable this feature on my controller which is running 5.1.163.0 version ?
Below is the message I am gettting
"AP on the 802.11a radio with Base Radio MAC X.X.X.X.X.X(APXXX) is unable to associate.
The regulatory domain configured on it '-A' does not match the controller's regulatory domain: -N"
Your help is much appreciated !!!
05-09-2009 06:25 AM
Look under the Wireless Tab and then on the left there should be a link to Country. You choose the country the ap is in.
05-10-2009 11:18 PM
Hi Fella5,
Appreciate your input but the Controller and the access points are installed in Australia, The Country Code on the Controller is already configured for AU. I am suspecting it has to be with the domain hard-coded on the AP when it was originally purchased. The model number of the AP is AIR-AP1242AG-A-K9 .. any idea how I can identify what is the domain configured/hard-coded on it ? There is a broken link on Cisco which could give the answer. Any help is much appreciated.
Cisco broken link
http://www.cisco.com/application/pdf/en/us/guest/products/ps5861/c1650/cdccont_0900aecd80537b6a.pdf
05-11-2009 03:24 AM
Here is a better link:
05-12-2009 03:15 PM
That is the link I was looking for
Cheers,
05-11-2009 03:53 PM
Hi Fernando,
I think it's because of the FCC Compliance code. The "A" or "N" means that your model, which has the "A", is FCC Compliant. You should've gotten the non-compliant version, the "N".
Contact Cisco and ask them if they are able to replace it with something else. How did you wind up with a US version for Australia is a puzzle by itself.
Hope this helps.
05-12-2009 03:13 PM
Hi leolaohoo
"How did you wind up with a US version for Australia is a puzzle by itself". You know I have inherited it so I can't comment on this.
If the AP are for US then it should be Ok to configure AU and US on the controller. I will do that .. some channels might not work .. I will have to test that.
Cheers,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide