05-09-2009 09:20 AM - edited 03-14-2019 04:04 AM
I have a script that dials outbound using the "PLACE CALL" step.
Once it connected it runs a get digit step where it asks for digits from the person it called "Enter Code"
The person on the other end is supposed to enter a code, but the digits are not being recognized.
It's almost like a "reverse" DTMF-Relay issue, but POTS dialpeer's don't have DTMF relay options.
Any thoughts?
05-09-2009 12:18 PM
I tried this via a SIP trunk and same result.
05-10-2009 03:13 AM
if u send the call to ur CCM through a VOIP dial-peer and ur GK is H323
u need the follwoing command under ur VOIP dial-peer toward CCM
dtmf-relay h245-alphanumeric
HTH
05-10-2009 09:04 PM
these are outbound calls - so they don't hit a VoIP peer.
01-14-2010 11:04 AM
I've run into the same issue. Did you ever find the resolution?
01-18-2010 01:48 AM
Please make a SIP trunk with MTP enabled. It should help.
01-18-2010 05:36 AM
Two things to add on this thread:
01-18-2010 07:53 AM
I found my issue. There was no outbound dial peer on the gateway and the outbound calls were hitting the default dial peer. Once the outbound dial peer was added, it worked fine.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: