gogasca Mon, 05/11/2009 - 00:57

If using cucm, you can setup regions accordingly and have proper transcoders that support both codecs

check cucm srnd media resources section

nkariyawasam Mon, 05/11/2009 - 01:01

I was just trying to configure HW media resource ( 28XX router) using Cisco Online DSP calculator tool. Under the transcoding and coinferencing seciton it never shows g.723 selections. Only g.711 and g.729 are shown.

nkariyawasam Mon, 05/11/2009 - 02:00

I do not have catalyst switch in this particular installation . Is there any way that I can configure a router-based conferancing resource for this requirement ?

Actions

This Discussion