05-10-2009 10:59 PM - edited 03-15-2019 05:56 PM
Is there any way that I can do transcoding and conferencing between G.723 to and from G.711 and /or G.729 ?
Thanks.,
05-11-2009 12:57 AM
If using cucm, you can setup regions accordingly and have proper transcoders that support both codecs
check cucm srnd media resources section
05-11-2009 01:01 AM
I was just trying to configure HW media resource ( 28XX router) using Cisco Online DSP calculator tool. Under the transcoding and coinferencing seciton it never shows g.723 selections. Only g.711 and g.729 are shown.
05-11-2009 01:16 AM
C510 does not support g.723 codec for transcoding
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/srnd/7x/media.html#wp1046264
CMM does:
WS-SVC-CMM-ACT
05-11-2009 02:00 AM
I do not have catalyst switch in this particular installation . Is there any way that I can configure a router-based conferancing resource for this requirement ?
05-14-2009 12:33 AM
no
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide