Solved: MPLS VPN with VPNv4 route reflection

souagarw · ‎05-11-2009

We need to configure export and import RTs in a VRF so that while VPNv4 routes are exchanged between PEs so that PE will know which VRF a particular VPNv4 route has to be installed based on RTs. If RTs are not configured, then routes will not be installed in BGP routing table (exception if no bgp default route-target filter command is used).

However, if route reflector is used and PEs are estabalishing VPNv4 neighborship with RR, I noticed even without "no bgp default route-target filter" command, routes are getting exchanged and present in BGP routing table.

My question is with RR, is this an expected behavior that command is not required and still routes gets exchanged because routes are just getting reflected to other PEs.

Regards

Sourabh

shivlu jain · ‎05-11-2009

hi sourabh

by default all the routes install in the bgp table w.r.t vrf configured or not. This is simply wastage of memory. So after adding the command "no bgp default route-target filter" only those routes will be installed whose vrf need to be configured on that router.

By default when router is made RR, it si the default behavior with it.

regards

shivlu jain

View solution in original post

shivlu jain · ‎05-11-2009

hi sourabh

by default all the routes install in the bgp table w.r.t vrf configured or not. This is simply wastage of memory. So after adding the command "no bgp default route-target filter" only those routes will be installed whose vrf need to be configured on that router.

By default when router is made RR, it si the default behavior with it.

regards

shivlu jain

souagarw · ‎05-11-2009

Ok, so you mean when VPNv4 RR is used all the routes install in the BGP table irrespective of VRF configured or not. So, "no bgp default route-target filter" is enabled by default for VPNv4 RRs?

shivlu jain · ‎05-11-2009

yes, you are very much right.

regards

shivlu jain