05-11-2009 08:13 AM - edited 03-11-2019 08:30 AM
So I was poking around my ASA5505 today and noticed the port I have connected to my 1242AP had a ton of switch ingress policy drops. ASA's been on for about 10 days but there are around 12 billion of them.
I read something about the vlan interface name, but both vlans are named.
Any ideas?
Interface Ethernet0/7 "", is up, line protocol is up
Hardware is 88E6095, BW 100 Mbps, DLY 100 usec
Full-Duplex(Full-duplex), 100 Mbps(100 Mbps)
Available but not configured via nameif
MAC address 001b.54eb.da41, MTU not set
IP address unassigned
5331418 packets input, 706126156 bytes, 0 no buffer
Received 906548 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 L2 decode drops
12884915546 switch ingress policy drops
6231312 packets output, 4126940935 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collisions, 0 deferred
0 lost carrier, 0 no carrier
0 rate limit drops
0 switch egress policy drops
05-11-2009 11:15 AM
paste the interface configs of ASA and switch port where its connected
05-11-2009 11:18 AM
This is the port on the ASA:
interface Ethernet0/7
speed 100
duplex full
It's connected to my 1242AP. Config for the ethernet port on that device:'
interface FastEthernet0
no ip address
no ip route-cache
speed 100
full-duplex
bridge-group 1
no bridge-group 1 source-learning
bridge-group 1 spanning-disabled
hold-queue 160 in
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide