cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
4166
Views
0
Helpful
3
Replies

DTMF tones not recognized on SIP trunk PSTN calls

efrazee
Level 1
Level 1

I have a SIP trunk to the PSTN when I make calls through my gateway over the SIP trunk to PSTN DTMF is not recognized. My VOIP dial peer looks like

dial-peer voice 5001 voip

description SIP DIAL-PEER TO TELCO

destination-pattern 9[2-9]..[0-9]...

progress_ind setup enable 3

progress_ind progress enable 8

session protocol sipv2

session target ipv4:69.51.100.172:30026

session transport udp

incoming called-number .

dtmf-relay rtp-nte digit-drop

codec g711ulaw

ip qos dscp ef signaling

no vad

My SIP trunk provider says they are not seeing the DTMF on there end.

3 Replies 3

efrazee
Level 1
Level 1

I changed the dtmf-relay to

dtmf-relay rtp-nte cisco-rtp

and it works

dial-peer voice 5001 voip

description SIP DIAL-PEER TO TELCO

destination-pattern 9[2-9]..[0-9]...

progress_ind setup enable 3

progress_ind progress enable 8

session protocol sipv2

session target ipv4:69.51.100.172:30026

session transport udp

incoming called-number .

dtmf-relay rtp-nte cisco-rtp

codec g711ulaw

ip qos dscp ef signaling

no vad

Can you send your SIP configuration? I have it set up the same way, and I still do not get dtmf no do I hear the ringback.

Thanks

FYI.. I upgraded my IOS from 12.4 (20)T to 12.4 (24)T and it fixed my dtmf issue. I still don't hear ringback, however.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: