cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
445
Views
0
Helpful
4
Replies

transcoding question: g.723 to other codecs

nkariyawasam
Level 1
Level 1

Is there anyway that we can use normal router-based DSP resources to do trascoding from G.723 to other codecs ( G.711 and G.729) ?

4 Replies 4

Jaime Valencia
Cisco Employee
Cisco Employee

It's the ONLY way, you forcefully need a XCODER with DSPs to do that conversion

Configuring Enhanced Conferencing and Transcoding for Voice Gateway Routers

http://www.cisco.com/en/US/docs/ios/12_3/vvf_c/interop/intcnf2.html

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

I am refering to the "Table 5 DSP Theoretical Session Capacities " under chapter "Configuring Enhanced Conferencing and Transcoding for Voice Gateway Routers" of your URL.

It says that G.723 supported for voice termination. But nowhere mension about transcoding to and form G.723. Anu ideas ?

Thanks,

it's a high complexity codec, so refer to table with G.729, G.729b.values

6 Sessions per DSP, meaning you would need 4 DSPs to support a T1 either XCODER or voice termination (which in practical terms do the same function)

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

Thansk for the reply.

Yes I agree with you that g.723 is high complexity codec. But what I am wondeirng is that G.723 is mentioned under "voice tramination" in the same table, But for transcoding it never mention G.723 codec. Can this be a mistake?

Thanks,

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: