Hi Experts,
I need to upgrade IOS on one of my Core-switch 4507.
The present IOS verison is atalyst 4500 L3 Switch Software (cat4500-NTSERVICESK9-M), Version 12.2(31)
I need to upgrade this to 12.2(50) then it will support to run NetflowAnalyser.
Experts can anybody help me out how shall I proceed in terms of download software and upgrade it on present version.
Please find the below present IOS verison details, memory detials and environmental details.
DK-DATACENTER-CORE01#sh memory
Head Total(b) Used(b) Free(b) Lowest(b) Largest(b)
Processor 12750A48 495646132 229929648 265716484 264476724 253322836
DK-DATACENTER-CORE01#sh ver
Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500-ENTSERVICESK9-M), Version 12.2(31)SGA, RELEASE SOFTWARE (fc3)
cisco WS-C4507R (MPC8245) processor (revision 14) with 524288K bytes of memory.
Processor board ID FOX102800F8
MPC8245 CPU at 333Mhz, Supervisor IV
Last reset from PowerUp
50 Virtual Ethernet interfaces
148 Gigabit Ethernet interfaces
403K bytes of non-volatile configuration memory.
DK-DATACENTER-CORE01#sh environment
no alarm
Chassis Temperature = 35 degrees Celsius
Chassis Over Temperature Threshold = 75 degrees Celsius
Chassis Critical Temperature Threshold = 95 degrees Celsius
Power Fan Inline
Supply Model No Type Status Sensor Status
------ ---------------- --------- ----------- ------- -------
PS1 PWR-C45-1400AC AC 1400W good good n.a.
PS2 PWR-C45-1400AC AC 1400W good good n.a.