NAT pool and overloading

Answered Question
May 12th, 2009
User Badges:

Hello


I have such configuration:

Router(config)# ip nat pool net-208 209.165.202.1 209.165.202.15 netmask 255.255.255.240

Router(config)# access-list 1 permit 192.168.1.0 0.0.0.255

Router(config)# ip nat inside source list 1 pool net-208 overload

Router(config)# interface ethernet 1

Router(config)# ip nat inside

Router(config)# interface ethernet 0

Router(config)# ip nat outside


I have 15 outside addresses and i use overload. How will these addresses be allocated for my internal users ? Will they all be used in round robin fashion ?

For example if all of my interlan users (254) browse www server will all outside addresses be used and will have similar number of translations ?


Thanx

Correct Answer by Jon Marshall about 7 years 10 months ago

My understanding is that the first 14 users will use a unique IP from the 209.165.202.1 -> 14 range and then all other clients will be overloaded on the last available address.


Jon

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Jon Marshall Tue, 05/12/2009 - 04:39
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

My understanding is that the first 14 users will use a unique IP from the 209.165.202.1 -> 14 range and then all other clients will be overloaded on the last available address.


Jon

Actions

This Discussion