IP to MAC address binding in 3560G switch

Unanswered Question
May 12th, 2009

Dear All,

I am trying to bind IP Address with the MAC address of the User PC because I placed an acl to allow only specific IP addresses to go on Internet,

But some users enter the same IP address which is allowed in the ACL,

I want to bind permitted IP with the User MAC address,,

I found following commands but its not working,

Switch# configure terminal

Switch(config)# interface gigabitethernet0/1

Switch(config-if)# ip verify source port-security

Switch(config-if)# exit

Switch(config)# ip source binding 0013.2074.144c vlan 10 192.168.10.5 interface

gigabitethernet0/2

The user is in the vlan 10, while testing my configuration, I shut down the original computer (permitted) and entered the same ip on any other system within the same vlan,, It accepted the IP and started working normally..

Please advise, do i need to configure something else...

Regards,

Junaid

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion