Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
528
Views
0
Helpful
2
Replies

Multilink with QoS

derek.leonard
Level 1
Level 1

‎05-13-2009 09:38 AM - edited ‎03-06-2019 05:42 AM

Not sure if this is under the right spot or not ...

I have a PPP multilink running on 3845's. There are 3 T-1's in the multilink, and under the multilink interface a service policy is set. On the serial interface configurations, the fair-queue option is there. My questions is, is this option negating the service policy, or should the service policy output command be under every serial interface in the multilink? thanks for any help.

sample config:

interface Multilink5

ip address x.x.x.x x.x.x.x

ppp multilink

ppp multilink group 5

service-policy output test

interface Serial0/1/0

no ip address

encapsulation ppp

fair-queue

ppp multilink

ppp multilink group 5

Labels:
0 Helpful
2 Replies 2

Jon Marshall
Hall of Fame
Hall of Fame

‎05-13-2009 10:02 AM

Derek

The service-policy should be applied to the multilink interface and not to each individual physical interface so your setup is correct.

Jon

0 Helpful

derek.leonard
Level 1
Level 1
In response to Jon Marshall

‎05-13-2009 10:04 AM

Thanks Jon. So the fair-queue command on the serial interfaces is not negating anything?

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card