Invalid call reference value

Unanswered Question
May 13th, 2009
User Badges:

Hi,


I have a PRI terminated into Cisco 2821 Router. All the 30 chanels are allocated to us. The problem is from Voice gateway whenever we make outbould calls we get the error message " Cause i = 0x8AD1 - Invalid call reference value ". But we can find the calling party no in the router.


Plz find the debug for the outbound calls.

=============================================================


aredxbhobvgwan01#isdn test call interface serial 0/1/0:15 2337777

4294967296w4294967296d: ISDN Se0/1/0:15 Q931: Sending SETUP callref = 0x00AD callID = 0x802E switch

= primary-net5 interface = User

1w0d: ISDN Se0/1/0:15 Q931: TX -> SETUP pd = 8 callref = 0x00AD

Bearer Capability i = 0x8890

Standard = CCITT

Transfer Capability = Unrestricted Digital

Transfer Mode = Circuit

Transfer Rate = 64 kbit/s

Channel ID i = 0xA9839F

Exclusive, Channel 31

Called Party Number i = 0x81, '2337777 '

Plan:ISDN, Type:Unknown

1w0d: ISDN Se0/1/0:15 Q931: RX <- CALL_PROC pd = 8 callref = 0x80AD

Channel ID i = 0xA9839F

Exclusive, Channel 31mon

1w0d: ISDN Se0/1/0:15 Q931: TX -> RELEASE_COMP pd = 8 callref = 0x00AD

Cause i = 0x8AD1 - Invalid call reference value


1w0d: ISDN Se0/1/0:15 Q931: TX -> RELEASE_COMP pd = 8 callref = 0x00AD

Cause i = 0x80E6 - Recovery on timer expiry

4294967296w4294967296d: ISDN Se0/1/0:15 **ERROR**:CCPCC_CallOrigination:SETUP timed-out (2nd T303) to NETWORK.The SETUP failed.

====================================================================


All parameters are in sync with ISP.


Plz suggest.





  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Paolo Bevilacqua Wed, 05/13/2009 - 10:06
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Exact IOS? Can you send show controllers E1 ?

chrysostomos1980 Thu, 07/01/2010 - 07:32
User Badges:
  • Silver, 250 points or more

Hi to all


i didnt open a new document since we have the same problem here


Pls someone can help with this problem


i am experiencing the same problem(But this time the problem appeared only in incoming calls and not to outgoing)


ei controller 0/1/0


incoming:problem

outgoing:ok

Actions

This Discussion