2106 Controller with multiple 1141 APs

Unanswered Question
May 13th, 2009
User Badges:

I have a 2106 controller that I've been able to configure using the console port and enable the GUI. Its my understanding that the 1141's need the controller to be able to be configured, however, when I connect them to the 2106 I can see the waps but I can't save any of the settings (Name, static IP). I was looking at some of the documents that Cisco has produced, and the "Global Settings" option is not in the controller that I have, do I need a firmware upgrade? Or is there a reason why the controller can't make any changes to the wap's?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
vinunes Wed, 05/13/2009 - 15:38
User Badges:
  • Cisco Employee,

If your are runnning a 1140 series AP then you must use Controller (2106) code version 5.2 or greater.

Actions

This Discussion

Related Content

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode