×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

WAAS error message

Unanswered Question
May 14th, 2009
User Badges:

Hi there,


Seeing the following syslog message every couple of mins on a WAVE-574 running 4.1.3 -


2009-05-14 11:27:00 Local0.Warning 10.37.1.5 2009 May 14 10: kernel: %WAAS-SYS-4-900000: time.c: can't update CMOS clock from 75 to 27

2009-05-14 11:28:00 Local0.Warning 10.37.1.5 2009 May 14 10: kernel: %WAAS-SYS-4-900000: time.c: can't update CMOS clock from 76 to 28


TIA,

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Zach Seils Wed, 05/20/2009 - 07:51
User Badges:
  • Cisco Employee,

Brian,


This message means that the system clock is more than 15 minutes off from the time set by NTP. Try the following:


1. Disable NTP.

2. Set the system time with the command 'ntpdate'.

3. Enable NTP.


Regards,

Zach


cwehrstedt Wed, 11/24/2010 - 12:07
User Badges:

I am also getting this error, and I have checked the clock on  the inline devices and the CM and all are set insync.  Any other ideas?


kernel: %WAAS-SYS-4-900000: time.c: can't update CMOS

Brian Cartledge Thu, 11/25/2010 - 00:57
User Badges:

This thread is over a year old. I don't think the WAAS community existed when I posted it. FWIW we had to RMA the WAAS with this error.

Actions

This Discussion