Warm Insertion of WS-SUP32-GE-3B in C6509

Answered Question
May 14th, 2009

Even though we know most of the modules are warm insertable (hot swapable), are there any experience, comment or recommendation about inserting a WS-SUP32-GE-3B (the second supervisor) on Warm?.

Thanks in advance,

Juan Salgado

I have this problem too.
0 votes
Correct Answer by Leo Laohoo about 7 years 7 months ago

Hi Juan,

Just make sure the IOS of the new Sup blade is the same with the current one. Also make sure that there is NO configs available.

Correct Answer by Giuseppe Larosa about 7 years 7 months ago

Hello Juan,

you can install the sup on the live chassis, take care of electostatic charges connecting your body to the chassis

see

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/hardware/Config_Notes/78_16999.html

Your own ESD-prevention equipment or the disposable grounding wrist strap included with all upgrade kits, field-replaceable units (FRUs), and spares

Hope to help

Giuseppe

Hope to help

Giuseppe

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
Correct Answer
Giuseppe Larosa Thu, 05/14/2009 - 08:38

Hello Juan,

you can install the sup on the live chassis, take care of electostatic charges connecting your body to the chassis

see

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/hardware/Config_Notes/78_16999.html

Your own ESD-prevention equipment or the disposable grounding wrist strap included with all upgrade kits, field-replaceable units (FRUs), and spares

Hope to help

Giuseppe

Hope to help

Giuseppe

jssalgado Thu, 05/14/2009 - 10:43

For sure it helps.

Thanks a lot. I just needed that little trust from your experience.

Juan Salgado

Correct Answer
Leo Laohoo Thu, 05/14/2009 - 15:43

Hi Juan,

Just make sure the IOS of the new Sup blade is the same with the current one. Also make sure that there is NO configs available.

Actions

This Discussion