SPA3102 - How to turn off the ringing the station?

Unanswered Question
May 14th, 2009

Hello,

an incoming call rings at the station (SPA3102) _and_ the phone.

Is there a way that only the attached phone rings and shows

the CID?

Or is there at least a way to change the volume and/or tone of

the station?

Regards,

Peter

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Patrick Born Thu, 05/14/2009 - 10:43

Hi Peter,

You can change the ring sent to the phone: Voice tab > User 1 tab > Ring Settings > Default Ring:

Refer to the Admin Guide for additional details:

Available from: https://www.myciscocommunity.com/docs/DOC-2149

Direct link: http://www.cisco.com/en/US/docs/voice_ip_comm/csbpvga/ata/administration/guide/ATA_AG_v3_NC-WEB.pdf

We have no other control over an analog phone, so you could physically adjust the phone's ring volume or turn its ringer off.

Regards,

Patrick

----------

purpuroni Sun, 05/17/2009 - 10:10

Hi Patrick,

Thank-you very much for your answer.

As I changed in the same time the wireless phone which stood next to the SPA3102, I mistook the ringing of the basestation of the DECT-phone for bell of the SPA3102. But luckily your answer pointed in the right direction and the case could be solved easily.

Regards,

Peter

Patrick Born Tue, 05/19/2009 - 04:57

Hi Peter,

Ahhh! I wondered what was causing the ringing. :-)

Thanks for letting me know that the issue is resolved.

Regards,

Patrick

----------