Transparent ASA's in active/active?

Unanswered Question
May 14th, 2009

Hi Guys,

I have a bit of a problem where i have to configure an existing transparent 5520 asa to an active/active setup. Never done active/active before but i understand i have to create contexts etc. However Im not sure how this will work on transparent firewalls as i understand that the interfaces on each contexts need adressing(standby/backup).

Is there any other way active/active is achieved in transparent mode? Im tearing my hair out with this one so even a hint of help is greatly appreciated. Thanks

info: routers setup in hsrp on the inside interface and outside interaface.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
bwalchez Wed, 05/20/2009 - 06:00

Active/Active Failover is only available on units that run in multiple context mode

Actions

This Discussion