AP Rogues 'On Network'

Unanswered Question

We see several Rogue APs in our network which are, according to WCS, not 'On Network'. However, most of them do turn out to be 'On Network': their MAC address appears as connected&active in a switch port. I wonder if this is because the 'On Network' status is never re-examined after first detection? Any suggestions?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
jeff.kish Fri, 05/15/2009 - 04:56

How is the MAC active on a switchport but not on your network?

mark.cronin Fri, 05/15/2009 - 11:07

A couple of questions

1) What LWAPs are you using

2) Have you enabled Rogue Location Discovery protocol

3) Have you configured dedicated Rogue detector LWAPs

4) Have you got legacy Autonomous APs on your network

Leo Laohoo Sat, 05/16/2009 - 17:15

Forgive me but are we talking about plain Rogue AP or Rogue AP on Network Wire?

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode