I inherited a nework that has a 2851 router with the following config:
interface GigabitEthernet1/0
ip address 10.50.20.1 255.255.255.0
ip virtual-reassembly
!
interface GigabitEthernet1/0.1
encapsulation dot1Q 1 native
ip address 10.20.10.1 255.255.255.0
!
interface GigabitEthernet1/0.25
encapsulation dot1Q 25
ip address 10.20.20.1 255.255.255.0
I am not clear on why the physical int is configured with an IP address since there is two logical interfaces configured under it.
Also, this is a L2/L3 router and I am not sure how to access the L2 switch part of it.
Any help would be greatly apprecaited.
Thanks in advance,
sK