MPE-VT MPE and VIDEO

Unanswered Question
May 15th, 2009

Guys,

i have two labs here VT 2.X, and MPE 2.X. for the most part they are working fine but im unable to get the VIDEO working with the MPE.

to be a bit more clear, when im using either via a ad hoc video conference it works fine but when i try to use MPE for a video conference + web i dont get any video at all.

My lab consists of

5 IP Communicators running on XP

Cisco Cameras.

CODEC G711

ALL devices are registered

Two gateways H323 configured and registered on CUCM

Media resouce list has the conference bridge added and is working.

and adhoc vid conf is working

im using the 90 day trial license for MPE with 25 V/VI/WEB and 20V/6VI/6W for the VT

CUCM 6.X and MPE-VT AND MPE - 2.X

any assistance in what might be going on or even if im missing the obvious (as i realised after the fact that MPE-VT could ONLY do adhoc). as yuo might have noticed its my first time with this as well so any even basic input would be welcome.

thanks a lot in advance

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion