WAAS - WCCP causing problem in the AS400

Unanswered Question
May 15th, 2009

Hi All

We installed a WAAS in a bank environment and configured WCCP to redirect all traffic between the HO and Branch to the WAE devices

Everything worked fine except the AS400 replication between the 2 sites, it is sooooooo slow and when we denied the IP's of the AS400 from the WCCP REdirection, it worked very well.

NOTE: I created a new Policy with a classifier that match the IP's of the 2 AS400 and configured the application as REPLICATION, with FULL OPTIMIZATION.

Did any faced problem with the AS400 when implementing WAAS?

I will test by removing the new configured policy and send the AS400 traffic over the WAAS again.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
jorjes1984 Sat, 05/16/2009 - 01:24

I remove the manual configured policy and still had the same problem.

after removing the policy and configurint the AS400 traffic to pass via the WAAS, The traffic is having a policy applied (As shown in the connection statistics page), but still had the same problem ---> Very very slowwww

Please advise


This Discussion