Dear Adrian,

Thanks for the quick reply. please find attached the output of those 2 command . can you tell me where the DSP modules are installed ?

The 7200 chassis does not support direct installation of DSP modules.

Consequently, these are installed in the PA, as the output of the commands is telling you.

Dear,

Thanks for the reply.

Is it PA - Chanalized E1 port.

Thanks

Shibu

Dear Nick,

Please find the sh voice DSP.

-HQ#sh voice dsp

DSP DSP DSPWARE CURR BOOT PAK TX/RX

TYPE NUM CH CODEC VERSION STATE STATE RST AI VOICEPORT TS ABORT PACK COUNT

==== === == ======== ======= ===== ======= === == ========= == ===== ============

C549 010 01 g729r8 4.1.41 busy idle 0 0 1/1:15 30 0 6823409/5935

157

to determine where the dsp modules are installed try to issue show inventory command.

slawomir.daleszynski wrote:
to determine where the dsp modules are installed try to issue show inventory command.

You are responding to a 4 yeard old thread. The people involved have since then moved on.

Its still useful information Paolo, which is why they don't delete these threads.

Mark Ruhland wrote:
Its still useful information Paolo, which is why they don't delete these threads.

Being answering questions here (including this one) since years, indeed I'm aware of that.

R1# show inventory

really useful command for basic hardware lookup. Thanks 

It indeed helped! Thanks a lot