Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
497
Views
0
Helpful
3
Replies

IBM Blade Center

nawas
Level 4
Level 4

‎05-18-2009 06:09 AM - last edited on ‎03-25-2019 04:06 PM by Community Manager

We run DMZ and Internal network totally seperate, I have a business request to connect an IBM Enclosure to DMZ switch (as trunk) and to Internal network switch ( as trunk) so that some blades can talk to DMZ and some to internal network. If I have two set of switches ie 4 switches in the blade center, can I plug in two switches to DMZ and two to Internal. Is it even possible? I think IBM blade center architechture allows that I wanted to know if someone has done it here.

Thanks.

Labels:
0 Helpful
3 Replies 3

dgroscost
Level 4
Level 4

‎05-18-2009 12:11 PM

It's possible - at least with Bladecenter and Nortel L2/3 Copper switches. You configure the Nortel switch accordingly (trunk groups) and which ports that the internal Blades ports (typically 1-14) should be a member of.

0 Helpful

nawas
Level 4
Level 4
In response to dgroscost

‎05-18-2009 12:19 PM

I have Cisco IGESM switches in them. Will it work with these switches?

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card