Control Outgoing Calls on selective PRI lines

Unanswered Question
May 18th, 2009


I have a setup as below:

2 PRI lines are terminated on the Cisco Gateway.

The gateway is connected to a CCM 5.0.

My requirement:I want all outgoing calls should be dialed out from a Particular PRI based on some logic.

How can I control the outgoing calls to be dialled out from a particular PRI based on my choice.


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
acharyr123 Mon, 06/01/2009 - 10:54


You can do it under Route Group...

For your hint...

1. Register both the pri in the CCM.

2. Say PRI1: E1 0/1/0

3. Say PRI2: E1 0/1/1

4. Under Route Group select Top-Down in the selection criteria. Select 1st PRI on the Top & 2nd PRI then...

5. Means..alloutgoing calls will be thrown to 1st PRI. If 1st PRI is down/not available, calls will be routed via PRI2.

Rate if it helps..

Pranjol Saikia Tue, 06/02/2009 - 21:44

I want to control the outgoing calls,ie I want my CUAE based application to chose (based on some business logic) the PRI line through which the call should go


This Discussion