NetConfig

Answered Question
May 20th, 2009

When I run a netconfig job for all the devices, the job hangs in pending status. Sometimes it gets half the devices done, sometimes the job never starts. Is there something we have to do to have netconfig run? Whether it is ADHOC or a defined task, the same thing happens. Any help would be appreciated.

I have this problem too.
0 votes
Correct Answer by yjdabear about 7 years 6 months ago

If this is LMS 3.1 (I'm not sure about earlier versions), it's possibly one of the three bugs: CSCsv95235 CSCsw39641 CSCsw88378:

http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=Network%20Management&topicID=.ee71a02&fromOutline=&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.2cd25f87

A patch for these bugs is available from Cisco TAC. Just make sure the xdi.jar has the correct checksum of 326986eef9c9e46801a8623014ddd07e.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
yjdabear Wed, 05/20/2009 - 07:34

If this is LMS 3.1 (I'm not sure about earlier versions), it's possibly one of the three bugs: CSCsv95235 CSCsw39641 CSCsw88378:

http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=Network%20Management&topicID=.ee71a02&fromOutline=&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.2cd25f87

A patch for these bugs is available from Cisco TAC. Just make sure the xdi.jar has the correct checksum of 326986eef9c9e46801a8623014ddd07e.

pxcamp19 Mon, 05/25/2009 - 06:17

Thank you so much- this worked like a charm. My jobs are now successfully finishing-

Actions

This Discussion