Hello I need to know if I can to set the auto qos voip trust within of:
interface GigabitEthernet2/1
no switchport
no ip address
channel-group 2 mode active
spanning-tree portfast
end
CEM_PB_SW_CORE#conf t
Enter configuration commands, one per line. End with CNTL/Z.
CEM_PB_SW_CORE(config)#interface GigabitEthernet2/1
CEM_PB_SW_CORE(config-if)#auto qos vo
CEM_PB_SW_CORE(config-if)#auto qos voip tr
CEM_PB_SW_CORE(config-if)#auto qos voip trust
AutoQoS Error: AutoQoS can not be configured on member port(s) of a port-channe