Can I make a test VOIP call from Router CMD line

Unanswered Question
May 20th, 2009

I had a problem with my voip config,after some good advice from this forum I have made some change to the config.

are there any commands i can use to make a test voip call between the routers, so i can check if the new config works.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Nicholas Matthews Thu, 05/21/2009 - 05:29

csim start is a legacy command, and I find it only works well for pots test calls. The router doesn't have this capability, but csim start is the only command.

-nick

Actions

This Discussion