Looking for a MAC address generator?

Tks

Frank

I need to VERIFY if the IOS code really performs properly BEFORE I add this setup into my production environment.

I am hoping this config on interface G8/2 will accept up to 10 different MAC addresses. Once G8/2 receives the 11 different MAC address, Interface G8/2 will start ignoring any NEW MAC addresses for 5 minutes while allowing the current MAC addresses to continue passing data frames to/from the switch.

Also the switch will send a trap to the SNMP server to warn of the issue.

I.E. The switch will NOT shutdown the interface when a violation occurs.

interface GigabitEthernet8/2

switchport

switchport access vlan 7

switchport mode access

switchport port-security maximum 10

switchport port-security aging time 5

switchport port-security violation protect

switchport port-security aging type inactivity

load-interval 30

snmp trap link-status permit duplicates

storm-control broadcast level 70.00

storm-control multicast level 70.00

no cdp enable

no mop enabled

no mop sysid

no lldp transmit

no lldp receive

spanning-tree portfast edge

spanning-tree bpdufilter disable

spanning-tree bpduguard enable

spanning-tree guard loop

end