Previously Entered IOS Commands Missing from Sh Run Output

Unanswered Question
May 21st, 2009

On more than one occasion my colleagues and I have noticed that commands successfully accepted on interfaces don't show up in the show run output, i.e. I have put ip hello-interval eigrp 11 60 and ip hold-timer eigrp 11 180 on GRE tunnel interfaces on my branch 3725 router and my Core 6500 router. On occasion, I will not see the commands on the interface when I enter a show run. Is this a bug of the 122.33. SXF?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Giuseppe Larosa Fri, 05/22/2009 - 13:00

Hello Matthew,

EIGRP defaults to hello 60 seconds hold 180 seconds on multipoint interface with bandwidth <= T1.

if the GRE is considered multipoint and BW is less then T1 the values are not showed because they are the default values.

Are you using multipoint GRE with DMVPN ?

Hope to help



This Discussion