Add user to common services 3.x by command line

Answered Question
May 22nd, 2009
User Badges:

Hi guys,


anybody knows how I can add users to the CommonServices 3.x, using the command line interface?


There is a tool, script, class jar or executable?


Tks

Leonardo

Correct Answer by Marvin Rhoads about 8 years 2 months ago

Yes, the procedure is covered in the Common Services User Guide. See Chapter 4, Configuring the Server, Setting Up Security, Managing Security in Single-Server mode, Setting Up Local Users. It states, in part:


"To add local users through CLI, enter the following commands:

• NMSROOT/bin/perl NMSROOT/bin/AddUserCli.pl -add Filename Password (on Solaris)

• NMSROOT\bin\perl NMSROOT\bin\AddUserCli.pl -add Filename Password (on Windows)"


Syntax and other details are covered in the User Guide as well.


(This is all assuming your authentication mode is local. e.g., no ACS integration)

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Marvin Rhoads Fri, 05/22/2009 - 05:57
User Badges:
  • Super Silver, 17500 points or more
  • Cisco Designated VIP,

    2017 Firewalling, Network Management, VPN

Yes, the procedure is covered in the Common Services User Guide. See Chapter 4, Configuring the Server, Setting Up Security, Managing Security in Single-Server mode, Setting Up Local Users. It states, in part:


"To add local users through CLI, enter the following commands:

• NMSROOT/bin/perl NMSROOT/bin/AddUserCli.pl -add Filename Password (on Solaris)

• NMSROOT\bin\perl NMSROOT\bin\AddUserCli.pl -add Filename Password (on Windows)"


Syntax and other details are covered in the User Guide as well.


(This is all assuming your authentication mode is local. e.g., no ACS integration)

Actions

This Discussion