05-26-2009 06:47 AM - edited 03-06-2019 05:55 AM
Hi all
when I have qos enabled in my layer 2 switches, these switches then plugs into my layer 3 switch which routes to my distribution network,
what qos config do I need to do on the L3 switchports, can i still do a mls qos trust dscp ?
05-26-2009 09:21 AM
Carl,
Depends on what is being marked by L2 switch.
If it is COS bits then you have to use mls qos trust cos which should then be copied to DSCP bit at L3 switch.
If you are marking or remarking DSCP, then trust DSCP will do.
Either way, with QOS always test !
HTH
Sam
05-27-2009 03:30 AM
what is the best way to check ?
05-27-2009 03:35 AM
SPAN port + sniffer then you are 100% sure.
Else you could have use a policy map on a third device and see if your counters are incrementing for packets matching your class map.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide