CNC 5.1 wont install

Unanswered Question
May 27th, 2009

Whilst installing the CNC 5.1 i get the following error messgaes

openfile failed

then the cnc reads...

checking swap and disk space then

error message:

regDBGetKeyValueEx failed

then error message:

cannot create the install depedency file

the install then shuts down

any help would be great

cheers

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
yjdabear Wed, 05/27/2009 - 06:14

Could a simple case of what the message says--not enough disk space. What does "df -lk" (Sol 8/9) or "df -lh" (Sol 10) or "df -h" (Linux) look like? Any file system(s) that's nearly 100% full?

Actions

This Discussion