cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
379
Views
0
Helpful
1
Replies

CNC 5.1 wont install

bernards
Level 1
Level 1

Whilst installing the CNC 5.1 i get the following error messgaes

openfile failed

then the cnc reads...

checking swap and disk space then

error message:

regDBGetKeyValueEx failed

then error message:

cannot create the install depedency file

the install then shuts down

any help would be great

cheers

1 Reply 1

yjdabear
VIP Alumni
VIP Alumni

Could a simple case of what the message says--not enough disk space. What does "df -lk" (Sol 8/9) or "df -lh" (Sol 10) or "df -h" (Linux) look like? Any file system(s) that's nearly 100% full?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco