Unity Error

Unanswered Question
May 27th, 2009


Im doing a CCA Lab (UC500-CCA-First-Look-v1-Lab4), but there's a section in a lab the requiere to use the unity express Web config, but when I try to click on:


I get the following error:

Error: Unable to login as administrator to the Cisco CallManagerExpress at site 'local'.
Details: CME login failed

Thanks in advance.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
weeksgroove Thu, 05/28/2009 - 06:37

That isn't the config that is attached.

If you have not changed your IP addreses.  You should connect to  Once in there, you may have to run the CME/CUE setip wizard to make sure the CUE Admin and CME admin passwords are synd.

anbatist Thu, 05/28/2009 - 06:50

Now is the correct config. The Unity doens't allow me to run the initial wizard again, what can I do in this case?

Marcos Hernandez Thu, 05/28/2009 - 07:10

The CUE Setup Wizard is a one shot kind of deal. You would have to bring the system to factory defaults for it to show up again. Did you try the command that I suggested?


anbatist Thu, 05/28/2009 - 07:26

Hi Marcos,

With a lot of response (that is not a bad thing) I don't pay attetion to your response (excuseme man). Now I issue the command that you suggest (ip http path flash:/gui) and all my problems (excluding financial)

  were resolve.

thanks for your help.


This Discussion