05-27-2009 10:28 PM
Its LMS 3.1. Exporting the devices through the GUI or through the CLI times out. Eventually I have stop it or press CTRL+Z to quit the job. Also I cannot delete devices out of DCR. It says it was deleted, but when i look, its still there. It only 280 devices, and I'd like to start a fresh DCR database,since i suspect the current DCR database is corrupt. But i need those device type info and credentials, therefor the atttempt to export. So i can import them into a new CMF database. Any ideas?
05-28-2009 12:30 PM
This is most likely not a corruption issue, but some kind of communication issue. You could check the dcrimpexp.log for errors, or enable DCR Bulk Import/Export debugging, and see if anything stands out.
05-31-2009 01:05 AM
Hi joe, you were right. i just had to wait a while longer. I ran the dcrcli export command again. it completed after an hour. there was only 296 devices , but at least all the data was there. i'm relieved i didn't have to redo the install.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide