05-28-2009 06:19 AM - edited 03-06-2019 05:59 AM
Hi,
This is a simple question. I have 4948 switch but I don't know if I have any ports availabe to add an SFP module or whether they are all copper ethernet ports. How can I check what kind of ports are available as I don't have physical access to the switch.
Here's some info:
NAME: "Switch System", DESCR: "Cisco Systems, Inc. WS-C4948 1 slot switch "
PID: , VID: , SN:
NAME: "Linecard(slot 1)", DESCR: "10/100/1000BaseT (RJ45), 1000BaseX (SFP) Supervisor with 48 10/100/1000BASE-T p"
PID: WS-C4948 , VID: V06,
Thanks
Dan
05-28-2009 06:34 AM
Dan-
The last 4 ports (45-48) are dual personality; use can use the copper or the SFP port. If any of the ports are down, you can use an SFP in them.
Here's a picture for reference.
http://www.cisco.com/en/US/products/ps6026/prod_view_selector.html
Hope that helps.
05-28-2009 02:09 PM
Dan,
One other suggestion I would have would be to perform the "show interface status" command to determine if the ports in question are in use/active/or have any SFPs plugged in.
See reference from a 3750.
Port Name Status Vlan Duplex Speed Type
Fa0/48 notconnect 1 auto auto 10/100BaseTX
Gi0/1 notconnect 1 auto auto Not Present
Hope this helps, rate if it does.
JB
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: