Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

How to verify the following in 7960 IP Phone?

Unanswered Question
May 28th, 2009
User Badges:

Hi All,

How do I verify the following in 7960 IP Phone,

1. IP address of the phone

2. CME software version

3. Extension number

And how to access the GUI prompt of Cisco 7960 IP phone?

Thank you,

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Jaime Valencia Thu, 05/28/2009 - 10:45
User Badges:
  • Cisco Employee,
  • Hall of Fame,


you can use show commands:

Commands: show ss7 sm set through shutdown (voice-port)


Cisco Unified CME Commands: sast1 trustpoint through show fb-its-log


The whole config guide

Cisco Unified Communications Manager Express System Administrator Guide


To access phone GUI just type the IP of the phone in a browser



if this helps, please rate

david-lima Thu, 05/28/2009 - 10:54
User Badges:
  • Bronze, 100 points or more

Hi friend.

1. Settings->Network Configuration to check IP, Mask, Gateway, TFTP.

2. You can check only the firmware.

3. If the phone is configured, you can check directory number on the display of the phone.

To web access: http://IPPhone-IP

All the best



This Discussion