PRI Problem

Unanswered Question

Hi,

When configuring a PRI on a AS5350XM, I got the following output when I do show controller E1 3/0 :



E1 3/0 is down.


Applique type is Channelized E1 - balanced

Description: Vers Tunisie Telecom PRI 0

Far End Block Errors Detected

Receiver has loss of signal.

alarm-trigger is not set

Version info of slot 3: HW: 1032, PLD Rev: 7

Framer Version: 0x9



Framing is CRC4, Line Code is HDB3, Clock Source is Line.

Data in current interval (60 seconds elapsed):

0 Line Code Violations, 0 Path Code Violations

0 Slip Secs, 60 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins

0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 60 Unavail Secs

Data in Interval 1:

3652 Line Code Violations, 0 Path Code Violations

0 Slip Secs, 900 Fr Loss Secs, 3 Line Err Secs, 0 Degraded Mins


Any suggestions to resolve this . ( In my opinion, it's a problem of câble, But I hope that I'm wrong, because it's an octal câble. I suppose I can't find anywhere but only through Cisco )


Thanks in advance for your help.


Best regards,

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
paolo bevilacqua Thu, 05/28/2009 - 10:58
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Receiver has loss of signal


Check your cabling, is a 75 or 120 Ohm termination.

Actions

This Discussion