05-28-2009 11:57 AM - edited 03-15-2019 06:15 PM
Hi,
We have VIC2-4FXO & EVM-HD (8FXS/DID) card installed into our Voice Gateway (2821)..VG & CCM (7.0) is integrated properly..
FXO ports are configured as Ground Start & in the Attendant DN we have given one of the extension numbers...
The problem is: whenever we want to dial outbould calls over FXO we get a fast busy tone, where as from Outside we can dial that FXO line & there is no issue with voice clarity..
All the FXO lines are showing OFFHOOK in idle scenario....
Attached output for command " debug voice ccapi inout".
05-28-2009 07:51 PM
your attachment is not included in this post ;-(
if you shut/no shut your fxo ports, do the go into on-hook?
also, are your dial-peer pointing to the FXO ports for outbound calls?
05-29-2009 01:53 AM
05-29-2009 04:26 AM
Which exact IOS is this ?
05-29-2009 06:29 AM
Platform: 2821( C2800NM-SPSERVICESK9-M, Version 12.4(20)T2
05-29-2009 02:03 PM
IOS should be fine. I think you FXO lines remain off-hook because of this:
http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a00800ae2d1.shtml
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: