AAA for AT switch

Unanswered Question
May 29th, 2009
User Badges:

The problem is authentication reporting in ACS 4.0 when user atempt to log in AT switch with AAA configured. When user is logged in switch there is no informaton about that in "Logged-in Users" report page, but when logging is failed information exists in "Failed Attempts" page. That is situation only with AT devices, not width cisco where all works good.

Does anybody have explanation for this???

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Jagdeep Gambhir Fri, 05/29/2009 - 12:50
User Badges:
  • Red, 2250 points or more

This reports works on the basis of aaa accounting (start stop). Make sure you have accounting enabled on AT switch.


Regards,

~JG


Do rate helpful posts

dubrava2003 Tue, 06/02/2009 - 00:37
User Badges:

Thank you for response, but in documentation for AT switches there is not configuration for accounting on tacacs server, only for authentication.

regards

Actions

This Discussion