AAA for AT switch

dubrava2003 · ‎05-29-2009

The problem is authentication reporting in ACS 4.0 when user atempt to log in AT switch with AAA configured. When user is logged in switch there is no informaton about that in "Logged-in Users" report page, but when logging is failed information exists in "Failed Attempts" page. That is situation only with AT devices, not width cisco where all works good.

Does anybody have explanation for this???

Jagdeep Gambhir · ‎05-29-2009

This reports works on the basis of aaa accounting (start stop). Make sure you have accounting enabled on AT switch.

Regards,

~JG

Do rate helpful posts

dubrava2003 · ‎06-02-2009

Thank you for response, but in documentation for AT switches there is not configuration for accounting on tacacs server, only for authentication.

regards