National Number Prefix - LATA, Intra-LATA numbers

Unanswered Question
May 29th, 2009

We have found where we can implement national number dialing prefix in service paramaters and adding 91 to the inbound caller-id works for the most part. Our service, however, is on PRI that support both local and LD calls on the same lines.

Our LEC does not allow us to dial 1 for a local or intra-lata call that is not actually LD. Calls that are from local or metro exchanges must be dialed without a 1.

Is there a way to implement this and create an exception for 'local' area codes?

We are on CCM 4.1.3 SR5d

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Dennis Mink Fri, 05/29/2009 - 09:26

Used your route patterns to do digit stripping for outbound calls. gimme some examples and I will explain how to do it


This Discussion