how to configure AIM-IPS module on 4215?

Unanswered Question
May 29th, 2009
User Badges:

my manager is installing a 4216 -w- 6.0 code. He is asking for whitepages on how to configure the 4-port module card. I'm not having any luck with locating "configuration" paper on this. Are there any instructions for this?


thanks, Kevin

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Farrukh Haroon Sat, 05/30/2009 - 05:45
User Badges:
  • Red, 2250 points or more

Are you looking for hardware installation or software?


The AIP-IPS module goes into routers and not sensors as your topic post states.

Are you looking to install a 4FE card or an AIM-IPS into a router?


The Hardware installation guide is here:


http://www.cisco.com/en/US/docs/security/ips/7.0/installation/guide/hw_installing_aim.html


For the 4FE card, the software configuraiton is just like any other module, there is no special configuration for the interfaces (they are just like the built-in sensing interface).


Regards


Farrukh

Actions

This Discussion