Cisco Pix 515 not allowing SIP Trunk Traffic from CCME to Sip Provider

Unanswered Question
May 29th, 2009

I have been unable to get my CCME to register to my sip provider since in installed my pix 515. can anyone advise on the proper config to pass sip traffic with nat?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Dennis Mink Sat, 05/30/2009 - 05:47

You will need to allow port 5060 UDP or TCP inbound into your firewall (on the outside interface), and statically NAT it to your CCME's private IP address


This Discussion