NAC : CAM control over switch using SNMP

Unanswered Question
May 31st, 2009


I have CAM , CAS in Central, OOB,Virtual,Layer2 lab

I can see on CAM the access switch ports status which means that SNMP works but when a user is logged on the access switch , the user vlan is not inforced to be changed to Auth vlan

and he remains in the trusted vlan which is already configured on the acces switch

I can change in configuration on the switch through CAM but the CAM itself cant change Vlan

thanks to advise me what part i am missing


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
ramkumar-b Tue, 06/02/2009 - 00:26

Please check the following items

a. configuring User Pages

b. configure VLAN Mapping

c. Configure Managed Subnets

d. Configure VLAN settings under Port Profiles

halim.abouzeid Fri, 06/12/2009 - 07:21

in the CAM, when you see the access switch ports status, click on the magnifying glass icon next to a port which is up and see if it's detecting the MAC address of the device which is connected to that port. If it is not it means that SNMP mac-notification is not configured properly. If CAM doesn't detect the MAC address of the device, it wont change the switchport vlan...


This Discussion