UC500 - sccp fxs with zone-based firewall

Unanswered Question
May 31st, 2009

I configure a UC500 with zone-based firewall. After that the fxs ports cannot be registered as sccp. I run the "show sccp all" and the cause code for the error is "TCP_CONN_ERROR". Any help?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Nicholas Matthews Wed, 06/03/2009 - 18:26

Make sure you allow every interface with voice to have tcp 2000 open to the ip address in your "ip source-address" command in telephony-service.



This Discussion