Catalyst Express 500 Setup while in production

Unanswered Question
Jun 1st, 2009

I have 2 Cat Express 500 switches in production, without IP addresses configured (to the best of my knowledge) If I hit the setup button to initiate the config process will it impact the devices connected to the switch? Is this something I can do during use without kicking people out?



I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
jpoplawski Tue, 06/02/2009 - 06:00

Last I recall, it would affect connectivity. It would be best to perform this work during non-production hours to be safe.

Hope this helps, rate if it does!



This Discussion