Two clusters at the same site. MGCP or H323 for (2) gateways

Answered Question
Jun 1st, 2009
User Badges:
  • Green, 3000 points or more

I have two clusters at the same site with ICT between the two. Unique DIDs between the two clusters. I have (2) voice gateways. The gateways will have (2) PRIs each. Im thinking of the following:


- Cluster A VG A MGCP

- Cluster B VG B MGCP

- ICT between Cluster A and B.


Incoming DID on Cluster A routes to Cluster B via ICT (RP basically) Vice versa.


Outbound calls will be available for their respective Gateway/cluster. Could AAR be used for spillover of outbound calls to the other gateway?


Would H323 be and different in this setup to make it easier or is it basically apples to apples between the two protocols.



Cheers and thanks!


Two clusters at the same site. MGCP or H323 for (2) gateways

Correct Answer by Chris Deren about 8 years 1 month ago

There is nothing unique here as far as protocol selection becuase you have ICT.

CM is a protocol transaltor, so it makes no difference, and your decision points should be the usual ones for selecting H323 vs MGCP.


HTH,


Chris

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Chris Deren Mon, 06/01/2009 - 09:54
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,
  • Cisco Designated VIP,

    2017 IP Telephony, Contact Center, Unified Communications

There is nothing unique here as far as protocol selection becuase you have ICT.

CM is a protocol transaltor, so it makes no difference, and your decision points should be the usual ones for selecting H323 vs MGCP.


HTH,


Chris

Actions

This Discussion